MATHIASEN MACHINERY, INC.

450 Town Street                                         Phone: (860)873-1423
East Haddam, CT 06423                             Fax:     (860)873-8866

SPECIFICATIONS
21-105
GE DIP FORMING CONTINUOUS CASTING

Click on photo for full size image!

· Ref. #21-105
· Dip Forming Process Line,  Capacity:  6 tons/hour, Consisting of:
1)  3 ton capacity stacker crane,  4' x 4' lift bed, 5 motors, 20 lift height,  58' span, Honeywell programmable controls
2)  Vacuum Destacking System, 500 lb. capacity, 42" x 12' roller bed, Electric eye control
3)  Preheat oven, Gas fired, Continuous roll hearth, Operating temperature 1600o F
4)  Inert Gas Atmosphere Generator
5)  Melt Furnace - Ajax Magnethermic Drum type, Channel Induction Furnace, Two 450 KW fan cooled inductors, Operating temperature 2100o F, 6 tons/hour melt rate, Molten capacity 50,000 lbs.
6)  Pressure/pour hold furnace, two section (Ajax Magnethermic Model 2FWA1), Dual hearth, Two 120 KW undirectional flow inductors, 1157 amps, Operating temperature 2100o F, Molten capacity 15000 lbs.
7)  Vaughn Bull Block, Drawing & Shaving (reduce 1/2" rod to 3/8" rod), 50 hp DC drive motor, High speed steel shave dies
8)  Capstan & Vacuum Chamber, Falk capstan drive, 75 hp DC drive, Two Kinney 7-1/2 hp vacuum pumps, Molybdenum seals, 1-5 mm of mercury below atmosphere
9)  Cooling Chamber, Water cooled 70 GPM flow
10) Casting Crucible, Water cooled heating coil, 3000 HZ, 100 KW, power supply, 1983o F cast rod exit temperature, 1.7:1 accretion rate
11)  Waterbury Farrel Hot Rolling Mill, 5 stand tandem, Four (4) 40 hp and one (1) 50 hp DC drive motors, 1750 RPM, 8" dia. x 3" face rolls
12)  Cooling Tank, Hydromation Model HV-6H, 4 million BTU capacity, 425 GPM flow
13)  Vaughn Dead Block Coiler, 42" stationary block, 50 hp DC drive motor, Tilting turntable, Variable coil rate 0-1400 FPM
14)  3F Swager, 5 hp motor, 5/8" capacity
15)  Welder, 5/8" capacity
16)  Transformer Sub Station, Two (2) 2500 KVA oil filled transformers, 13,500 V primary, 480/277 Y volt secondary
17)  Power Control, Walk in air conditioned, Main AC incoming line 50,000 amp IC, Circuit breaker
18)  Standby Generator, 250 KW, diesel unit, 312.5 KVA, 375 amps
19)  Control Panels
 

If you have any questions or would like to receive further information on the above equipment please contact Mark or Mike Mathiasen.
 

We are always looking for good used Wire and Cable equipment to purchase for stock.  Please send us a list of any surplus machinery that you would like to turn into cash.

 Please contact us with your machinery requirements!
 

Back to MMI Home